Filtering Water In Koi Pond

Filtering Water In Koi Pond 
There are many ways to clean water in a koi pond, which each method can be done simultaneously or separately as needed. The method or technique to clean the pond include:

1. Using drain

To clean the debris or dedaun of which fall into the koi pond, can be used drain. Drain, which was rather long stalk with a bamboo or wood, allowing us to reach all areas of the pond.Material usually cloth trililin drain that absorbs little water. Small-eyed drain, which could also be used to clean dirt in the form of foam-water froth on the surface of the water. In addition, residual sewage sludge is not wasted moss will usually float to the surface of the water. All this dirt can be overcome with a drain. Do not miss too if there are fish that died (hopefully not) be taken with a drain.

2. Chiffon System

Siphon system is a way or method that can be used widely. One practical way using an ordinary plastic tubing to deliver water from the faucet. Provide a hose longenough, about 5 feet when his narrow pool, and 10 meters when the pool area.This method uses the elevation system. So dirt and water is sucked out through the hose together.The tip of hose is inserted into the water after the other until the other end. When the ka first tip is inserted, keep Do not let this tip to surface water, so that all parts of the hose filled with water and no air bubbles that stray inside. After all hose filled with water, pull one end of the hose and the lid with your thumb so that water remains in the hose. Once this end we take it to a lower place, the water in the pool to easily flow out.Edge hose inside pool placed on the dirty part. To facilitate the work we, the end of hose that was in the pool can be given a stalk. Thus from outside the pool we can "bring" hose to find the dirty parts. This method is very practical to remove the impurities that had crept.

3. System water pressure

Water pressure systems utilizing the principle of a quarter-ti chiffon, it's just that the pool must be equipped with a hole in the middle. Every pool shall be equipped with this hole. The hole can be created by installing a pipe pralon by 1 or 2 inches. Pralon hole is connected with the pre-lon a little long on the outside of the pool.If you want to clean the pool, next to the hole pralon be connected with a hose, in charge of looking for dung. At the time not used, this hole is closed with a short pralon faced upward. In this way will enable us to clean the dirt everytime we want, without worry one day we forgot to close the swimming hole so that the pool is not going to drought.

4. Chiffon an improved system

Another way to clean water is to use the principle of chiffon system combined with water pressure system. Building door disposal of pralon wide at the top of her and a narrow bottom. Dirty water will exit at the bottom of the pool because the water pressure coming through the door water intake. In this way we can dispose of dead water on the bottom as well as the dirt that had lurking at the bottom.In this way we can remove the water every morning, once a day when the fish is not active. With the disposal of dirty water and dying on a regular basis every day at least we are able to take part in maintaining the health of fish.

5. Pump system

If we have a pond full of koi, of course not possible for us to release water freely. However Do small Fiati, now available in the market has many small pump that can help us overcome this difficulty. This pump out water in addition to the dead and dirt, can also be used to increase aeration in the pond. This course can be associated when the pool is equipped with a rock waterfall, and the pump is used to turn water from the pond into the filter unit and brought up the new exit from the top.If the pump is only used as a means to clean water, should be operated in the morning. In the morning, debris still remains in the pond and the fish has not been so active, making it easier for our work. During the day when the temperature has gone up, the dirt in the bottom of the pond will rise and make it difficult when aspirated pump. The more dirt that has been floating would pecans when touched.

6. Water circulation system

The most recent effective and efficient way to clean the pool water is with water circulation system. By building a mini-ring filtering unit beside the pool, either with a permanent building or fiberglass tub, water from the pond increased and after passing through the filter unit of water back into the pool is clean. In the units given a foam filter to prevent dirt so that no water from ending. This foam should be washed every 2 or 3 days. In this way the work of cleaning the water to be practical and do not require much effort and cost.